Does anyone have a 3D model of the controller for invenor?

HuskyDread
Explorer

Does anyone have a 3D model of the controller for invenor?

I am trying to make an acessory for the controllers, and I want a 3D model so I can see the exact measurements. I am using AutoDesk Inventor 2016. Any help is appreciated. 

 

Community

Re: Does anyone have a 3D model of the controller for invenor?

Hi @HuskyDread, here's a link to the .STL and .STP files for the controllers: click here (4.6Mb ZIP)

 

You may need to do some work to get them into AutoDesk Inventor - a quick search turned up this.

Stephen 'Rockjaw' Reid
- Community Wrangler
HuskyDread
Explorer

Re: Does anyone have a 3D model of the controller for invenor?

Thank you so much! After a while I finally got it loaded up and it was amazing. Smiley Happy

HuskyDread
Explorer

Re: Does anyone have a 3D model of the controller for invenor?

Do you know if there is a why to resize it so that it is realistic? when I started looking at it, I realized it is too large to be realistic.

Community

Re: Does anyone have a 3D model of the controller for invenor?

Sorry @HuskyDread, I'm no 3D modeling expert. Smiley Sad

 

Hope you figure it out!

Stephen 'Rockjaw' Reid
- Community Wrangler
MarcoRomero_3D
Explorer

Re: Does anyone have a 3D model of the controller for invenor?

Hi @Rockjaw,
Attached the Vive Controller converted in OBJ file format, unit setup in centimeters: https://skfb.ly/67pqB

HTC Vive ControllerHTC Vive Controller

 

 

Marco Romero 3D Design Studio

Website: http://www.marcoromero.net
Facebook: https://www.facebook.com/MarcoRomero3D
LinkedIn: https://www.linkedin.com/in/marco-romero-45955217/
Unity Connect: https://connect.unity.com/u/581a1f0832b306001b43e486
MarcoRomero_3D
Explorer

Re: Does anyone have a 3D model of the controller for invenor?

Hi @Rockjaw,

Is there any chance of get this file in IGS format?

I tried using several techniques to make the 3D mesh conversion of this "Vive Controller" but the source files have errors. I ask it because I did the conversion of "Vive Tracker" from the IGS file format without any problems, so I think it could be better if I make the conversion directly from the IGS file.

I'll be looking forward your reply.

Bes regards,

Marco

MeshLab SoftwareMeshLab Software

 

 

Netfabb softwareNetfabb software

 

 

Marco Romero 3D Design Studio

Website: http://www.marcoromero.net
Facebook: https://www.facebook.com/MarcoRomero3D
LinkedIn: https://www.linkedin.com/in/marco-romero-45955217/
Unity Connect: https://connect.unity.com/u/581a1f0832b306001b43e486
Labels