06-27-2018 02:19 PM
I was using v0.8, I 'll definitely give v1.0 a try.
the issue I am facing is actually the firmware had been updated while the tracker was in controller configuration. and now when I connect and try to change it back it says no or multiple vive devices connected so unable to change the role.
I will try the newer version and let you know if it works.
07-02-2018 04:45 AM
This is the error i keep getting even with the V 1.0 Role Changer... I have connected only the tracker and no other vive device and i still get this error.
07-02-2018 07:16 AM
I assume you tried the reset found here:
It says to plug the tracker in to your PC and press the button for 10 seconds.
Also I use an old laptop for all my role changing, that way I don't have to exit/close VR or disconnect any gear because I don't have anything attached to the old laptop. I started doing this because I would get the error that something else was connected on my gaming rig. Come to find out it was my TP Cast software running in the background causing the error.
07-02-2018 07:31 AM
Here is a procedure for fixing firmware in a controller, not a tracker:
It describes how to boot a PC connected controller while pressing the trackpad button, putting it into a "USB Drive mode" allowing you to copy new firmware to the device.
I know this is for a controller not a tracker, but if you were to connect pogo pins 2 (ground) and 5 (trackpad button) as you powered up, maybe it would have the same effect?
Just a theory!
07-02-2018 01:04 PM - edited 07-02-2018 01:05 PM
@ahmad.farooq Is your tracker showing up in SteamVR at all?
07-04-2018 03:34 AM